Austrian Easter Egg Blowing: Step-by-Step

Updated November 14, 2026

Jump to recipe

Austrian Easter egg blowing (Eierpecken or Ostereier ausblasen) is the traditional technique of emptying a raw egg through a small hole so you can decorate the intact shell and hang it on an Easter tree (Osterbaum). The result is a lightweight, hollow ornament that keeps for years. The basic method uses a pin or egg piercer, a bowl, and your breath or a small pump. You will also need to wash and sanitize the eggs first because you are handling raw egg.

What You’ll Need

  • Fresh, clean eggs (preferably at room temperature)
  • A pin, thumbtack, or an egg piercer (available at kitchen supply stores)
  • A small bowl or cup to catch the egg contents
  • A long, thin skewer or a straightened paperclip to break the yolk
  • A rubber bulb syringe or an egg-blowing pump (optional, but much easier than mouth-blowing)
  • Warm soapy water and a mild bleach solution (1 teaspoon bleach per 1 quart/liter water) for sanitizing
  • A clean towel
  • Optional: a small funnel or a piece of straw to help direct the flow

Step-by-Step

  1. Wash and sanitize the eggs. Wash the eggs in warm soapy water, then rinse. Soak them in the bleach solution for 1–2 minutes, then rinse again and dry. This removes bacteria from the shell surface so you do not contaminate the egg contents or your work area.
  2. Decide on the hole size and position. For hanging on a tree, make a small hole at the top (pointed end) and a slightly larger hole at the bottom (rounded end). The bottom hole lets the egg flow out more easily. If you only want one hole, make it at the bottom and blow through a straw inserted into the hole.
  3. Pierce the top hole. Hold the egg firmly over a bowl. Gently twist the pin or piercer through the shell at the top end. Do not push hard—twist to avoid cracking the shell. Make a hole about 1/8 inch (3 mm) wide.
  4. Pierce the bottom hole. Turn the egg over and make a slightly larger hole at the bottom, about 1/4 inch (6 mm) wide. Again, twist gently.
  5. Break the yolk. Insert the skewer or paperclip into the top hole and move it around inside to break the yolk. This is essential—if the yolk stays intact, it will block the hole and the egg won’t come out.
  6. Blow the egg out. Hold the egg over the bowl with the bottom hole facing down. Place your mouth over the top hole, or use a rubber bulb syringe or pump. Blow steadily and firmly into the egg. The contents should flow out of the bottom hole into the bowl. If nothing comes out, the yolk may still be intact—re-insert the skewer and break it up more.
  7. Rinse the inside. Once the egg is empty, fill a small syringe with clean water and squirt it into the top hole. Shake the egg gently, then blow the water out. Repeat 2–3 times until the water runs clear. This removes any remaining egg white that could rot and smell later.
  8. Dry the shell. Place the blown eggs upright on a towel in a warm, dry place for at least 24 hours. They must be completely dry inside before you decorate or hang them, otherwise mold can form.
  9. Decorate as desired. Once dry, you can paint, dye, or add ribbons. For an Austrian Osterbaum, attach a thin ribbon through the top hole and tie a loop.

Common Mistakes

  • Making the holes too small. A tiny hole makes it almost impossible to get the egg out. The bottom hole should be at least 1/4 inch (6 mm) wide.
  • Pressing too hard when piercing. This cracks the shell, ruining it for decoration. Always twist the pin gently.
  • Not breaking the yolk. The yolk is thick and will block the hole. Always break it thoroughly with a skewer.
  • Blowing too hard. Excessive pressure can crack the shell. Blow steadily, not forcefully.
  • Skipping the interior rinse. Leftover egg white will dry into a crust that can harbor bacteria and produce an unpleasant odor over time.

Tips

  • Use eggs that are at least a few days old—fresh eggs have a thicker white that is harder to blow out.
  • If you plan to eat the raw egg, use it within 2 hours and refrigerate it. Do not use eggs that have been sitting at room temperature for more than 2 hours.
  • An egg-blowing pump (sold in craft stores) is far cleaner and more efficient than mouth-blowing. It costs a few dollars and saves a lot of breath.
  • To make the shell less brittle, some crafters soak the egg in vinegar for a minute before piercing—this slightly softens the shell, but it also makes it more fragile, so test on a spare egg first.
  • If you want to keep the egg contents for cooking, collect them in a clean bowl and refrigerate immediately. Use within 2 days.

Troubleshooting

  • Nothing comes out when you blow. The yolk is likely still intact. Re-insert the skewer and move it around vigorously. Also check that the bottom hole is not blocked by a piece of shell—use the pin to clear it.
  • The shell cracks while blowing. You are blowing too hard or the holes are too close together. Start over with a new egg. To reduce risk, hold the egg over the bowl and blow gently, letting gravity do most of the work.
  • The egg white is too thick to flow. This happens with very fresh eggs. Let the egg sit at room temperature for an hour, or add a few drops of water through the top hole to thin the white.
  • The shell smells after drying. You did not rinse thoroughly. Re-rinse with water and a drop of dish soap, then dry completely. If the smell persists, the egg was not fully dry before you stored it.
  • The bottom hole is too large and the egg slides off the tree branch. Use a smaller bottom hole next time, or tie a small bead or knot at the end of the ribbon inside the shell to keep it in place.

Frequently Asked Questions

Can I use hard-boiled eggs for blowing? No—hard-boiled eggs have a cooked white that won’t flow out. You must use raw eggs.

How long do blown eggs last? If thoroughly dried and stored in a dry place, they can last for years. Moisture is the enemy—any leftover moisture can cause mold.

Is it safe to eat the raw egg after blowing? Yes, if you used clean, sanitized eggs and kept the contents refrigerated. Use within 2 days. If you are pregnant, elderly, or have a weakened immune system, avoid raw eggs entirely.

What is the traditional Austrian way to decorate blown eggs? Austrians often use a special technique called Wachsbossieren—applying hot wax with a stylus and then dyeing the egg. The wax is later removed to reveal white patterns. Simpler methods include painting or using natural dyes from onion skins or beets.

Can I blow an egg with just one hole? Yes, but it is harder. Make a single hole at the bottom, insert a straw, and blow through the straw. The egg will flow out around the straw.

How do I hang the blown egg on an Easter tree? Thread a thin ribbon or string through the top hole using a needle or a piece of wire. Tie a loop at the top, and optionally tie a small knot or bead inside the shell so the ribbon doesn’t pull through.

Related

More recipes to cook

Safety notes: safe minimum internal temperatures from USDA FSIS; raw and undercooked fish guidance from the U.S. FDA. Food safety notes

Spotted an error? Tell us and we will correct it (corrections policy).